The Guitar Pickup winder is designed with guitar bobbins using thin wires. It can be used for winding guitar bobbins by using the wire. The winder comes with the bobbin wheel, which is directly attached to the motor shaft. The bobbin plate includes the threaded m4 holes, which come in multiple spacing. The bobbin possesses space for magnets, and it can be installed within the 10 mm diameter and 2 mm deep pocket. Let us go through this post to understand the pickup winder and the steps for building it. Mark The Spots for the Drill: The screw holes can be used for marking the points for drilling. The standoffs can be used as placeholders and can be helped with proper positioning. During drilling, the spinning is always done on the right side. If the transition can be done smoothly, the two rails have a minimum chance of breaking. Make sure you have enough spaces within the box for the counter. If it is difficult to drill holes, you can simply mark them with a simple ...